AfterMokit Replacement Frame Sliders with Acetal Pucks for Kawasaki Ninja 650 650R Ex650 2009 2010 2011 Carbon

Fitment:2009-2011 for Kawasaki ninja 650 Ex650 650RSee other customers' comments:1. Installed on my 09 ninja 650r, didn't come with instructions so it did take some time to figure out but i managed. Quite solid product overall though i do wish the RH side had a clamp to go over the frame to make it more secure or extend the threads just a hair farther on the bolt so the smooth section didn't bottom out.2. You do need to get off the fairings to install these, bolt the sliders onto the brackets with the hex bolts, I put the shorter slider with the thinner bracket and the longer slider with the thicker, they seem even on both sides like that... mount the shorter bracket on the clutch side of the bike, straight up and down, using two bolts, one long and one short and the longer spacer at the bottom and the slider protrudes through the fairings without the need to alter the fairings... mount the longer bracket on the throttle side, almost straight up and down, using one of the long bolts and the shorter spacer, just below the vertical frame bar and also protrudes through the fairings without the need to alter (use a second set of eyes to help you line this one up with the other side before you tighten it down). Once installed, they look great and are strong and worth it to protect the fairings.3. You have to remove the fairings to install them properly on a 2008 ninja 650r.

• Aftermarket replacement, Professional installation required, No installation instruction included
• Frame sliders help protect the frame, engine cases and fairings to minimize the cost of cosmetic repair
• If your fairings do not cover the engine mount position, you can install directly with No Cut. Otherwise please remove your fairings, mount the frame sliders onto the engine mount position, trim the fairings to allow the sliders to stick out
• How to use hex bolts: Bolt the shorter slider onto the thinner bracket while bolt the longer onto the thicker
• How to mount brackets: Bolt the shorter bracket onto clutch side by using 2 bolts(1 long one short) and the longer spacer while bolt the longer bracket onto throttle side by using 1 long bolt and the shorter spacer